• According to your request, your bearing is calculated as follows:

    According to your request, your bearing is calculated as follows:

    Since you did not give the temperature distribution (axis, bearing chamber), I only calculated the tolerance effect. Even so, since you did not give the tolerance of the bearing chamber, my calculation is only assuming the bearing chamber H7. If it is the shaft diameter of n6, if the bearing of 6324... read more

    May 31,2019 News
  • What you are saying is based on the color of the grease

    What you are saying is based on the color of the grease

    In addition, the tight fit you said, the clearance is small, resulting in discoloration of the oil. This reasoning should be like this: tight fit, small (remaining) clearance, increased bearing load area, and heat, resulting in oil denaturation, resulting in a change in grease color. And you said th... read more

    Jun 14,2019 News
  • The size of the bearing clearance

    The size of the bearing clearance

    The size of the bearing clearance, but the bearing after running will not have this problem. 1. The uneven distribution of grease in the new bearing is caused by the uneven distribution of the grease inside the bearing. In the initial stage of operation, there is a phenomenon of homogenization. 2. T... read more

    Jun 21,2019 News
  • The loss of the bearing itself?

    The loss of the bearing itself?

    The model of the selected bearing is 6020zz (medium hole 15, outer diameter 35). The motor on the production line is offline. When running at high speed, the no-load power is up to 200W, but if the motor runs continuously for 30 minutes, the power is only 50W. After the motor is completely cooled, w... read more

    Jun 29,2019 News
  • The inner ring of the bearing is fixed

    The inner ring of the bearing is fixed

    1. The inner ring of the bearing is fixed, the outer ring is rotated, what kind of cooperation is needed, how to choose the bearing clearance. What else should you pay attention to? What you are saying is that the inner ring of the bearing is fixed and the outer ring is rotating. This is just the op... read more

    Jul 05,2019 News